Bersa Pistol Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Trying to repair a Model 644 for a friend. The first round will strip and chamber properly, second round jams at an angle with bullet just entering chamber. The feed ramp looks good, I did some additional minor polishing, no difference. The extractor tip looks elongated and either causing or contributing to this condition. Not having a new extractor to compare, I wonder if anyone has any advise or photos of an unworn extractor or dimensions. Thanks a lot. I've owned several .380s and never had an issue.
 

·
Premium Member
Joined
·
1,043 Posts
Trying to repair a Model 644 for a friend. The first round will strip and chamber properly, second round jams at an angle with bullet just entering chamber. The feed ramp looks good, I did some additional minor polishing, no difference. The extractor tip looks elongated and either causing or contributing to this condition. Not having a new extractor to compare, I wonder if anyone has any advise or photos of an unworn extractor or dimensions. Thanks a lot. I've owned several .380s and never had an issue.
Welcome to Bersa Pistol Forum Kokomo45.
How old is your Bersa 644 - 22??

BERSA 644, .22LR:
Click to Enlarge
ORIGIN - ARGENTINA
CALIBER - .22 LR
WEIGHT - 26.5 OZ.
OVERALL LENGTH - 6.6"
LENGTH OF MAGAZINE - 3.89"
Made by Bersa S.A. Ramos Mieja, Argentina, this is the original Bersa.
SKU: 2000M

The info I found on the internet above implies that it is the Original Bersa. Is this the first model Bersa made???

Automotive lighting Bumper Automotive tire Gas Asphalt
 
1 - 2 of 2 Posts
Top